You'll hate me, but i need help.

What goes into the two connectors in the middle?
And where do you solder the power supply onto?

The power supply either plugs into the four pin connector or solders into the four spots near that connector. (it's all labeled)

The other connector is options for controls I believe.
(like for the buttons your machine does not currently have....fire, jump, whatever)
 
PACMAN ANGRY!

attachment.php
 

Attachments

  • pacman_up.jpg
    pacman_up.jpg
    45.3 KB · Views: 135
Last edited:
Just to give you something to think about...

I bought a lizard lick pcb and I tried it in a 100% working pac cabinet with a clean original pac board(no burt traces).

Plugged the lizard lick pcb and it did not work(orange screen and rolling). I think mine might have been before the redesign...

If your original harness is iffy/old, going with the jammaboards option will give you good +5, -5, +12, to the pcb.. The lizard lick is relying on the cabinets wiring.
 
Just to give you something to think about...

I bought a lizard lick pcb and I tried it in a 100% working pac cabinet with a clean original pac board(no burt traces).

Plugged the lizard lick pcb and it did not work(orange screen and rolling). I think mine might have been before the redesign...

If your original harness is iffy/old, going with the jammaboards option will give you good +5, -5, +12, to the pcb.. The lizard lick is relying on the cabinets wiring.

interesting. Thanks for the heads up.
 
Back
Top Bottom