Yokes

short or squished pic, blowing hots, blowing vertical ics, melted connector to name a few along with a abnormally low ohm reading...


whatcha got???
 
I have a bestech that has no burn that I was going to pull the tube from. I have a 4600 with good electronics and tons of burn. In the bestech, one side is 1.9 and the other was about 18 ohms. When I measured the 4600, I got 2.0 on one set and 0.0 on the other. I had been having problems with the 4600 blowing hots earlier.
 
thats a problem man.. 0.0 = 0 ohms= DEAD SHORTED...

soembody else is working on a tube swap and they ohmed the yoke.. check the post because itll have the proper reading...


make sure your checking it corrctly and make sure a blob of solder or a strand or wire didnt fall in there cahsing the short..


if your bestech yoke reading is close to the proper 4600 reading, you might be able to use it tube yoke and all...
 
Last edited:
Back
Top Bottom