xxxx-1 problems

kennyp2112

Member
Joined
Jan 3, 2008
Messages
868
Reaction score
11
Location
South Milwaukee, Wisconsin
I had a 1066-1 board which I then upgraded to a 1315-1 board. I installed the hard drive and new processor myself. In the first cab I tried it on it gave me a split screen...even though it was set on the proper setting. I recently changed cabinets ,hooked eveything up and now I'm having a problem with the board not booting. I turn on the power supply ....the led on the board lights for a milli second and then goes out.

I changed the hard drive and processor back to the original set and it still does the same thing.

Any insight into this?

Thanks

Ken
 
make sure your cable above the ps/2 ports is plugged in
if not it will come on for a second and shut off
 
look at the bottom of the board where the ps/2 is it might have come off underneath
 
sometimes where the cable is soldered underneath a wire might have come off
 
Back
Top Bottom