XM-2001N B+ voltage ? after cap kit/new flyback

PumRibby

Member

Donor 2015
Joined
Jun 4, 2015
Messages
295
Reaction score
11
Location
Alamogordo, New Mexico
Hi, I just installed a cap kit and new flyback in one of my Sharp monitors. After the install, the image had a ripple effect along the top inch of the border of the play field (Vindicators). I adjusted the b+ to 110v as per the manual and the ripple effect spread to the entire screen. When I bumped the voltage up to 113v, it went away completely. I've done two of these monitors before (Xybots, Blasteroids) and have never come across this issue. This is also the first one of the three I had to replace the flyback however. So the question is, how bad would it be to leave it at 113v?
 
3 volts won't matter enough either way. your good at 113
 
Back
Top Bottom