Museum of the Game® & International Arcade Museum® Forums

FIXED Thank You Everyone!!!!

At the end of September I picked up a true barn find red tent. When I went to pick it up there was a mouse nest the size of TX on the one chassis. As a result I did not turn the game on and took it as is. I took it home, stripped it all down, and cleaned it up. I have reinstalled everything. ISO is putting out 105 which all of my Nintedno ISO's have.

Monitor One: No signs of mouse activity or damage. I reinstalled it today, and the yoke started sparking as soon as I powered it on. Clearly a bad yoke.

Monitor Two: Had chewed wires so I found a tested and working replacement chassis. I just installed that onto the tube. The tube will not power on and I just get a tick, tick, tick. The previous owner ran it for a while before shipping it off. So I would assume it's not the chassis.

The fuses on both chassis are ok. so fingers crossed no damage there.

Hopefully the tube for monitor one is ok. I don't have a tester on hand to check it.

Monitor one I will need to meter out the yoke and then pull it and look for damage.

I'm not sure where to start with monitor two. Any suggestions?
Back
Top Bottom