WTT for a 100% working battlezone pcb

LUCKYMAN

New member
Joined
Sep 22, 2008
Messages
6,465
Reaction score
54
Location
Clifton Heights, Pennsylvania
Rating - 100%
86   0   0
I need a 100% working battlezone pcb set.. I have to trade for one:

100% working TRON pcb set

100% working CHEYENNE pcb set

100% working pole position set

If you dont want to trade, then shoot me an offer for your BZ set...
 
ywha, im sure that would go over really well :)
I would prob let you have it back, but after a week it developed issues. It mostly works but there are no fire sounds or impact sounds. Everything else works. If you want it back i will make you a deal, im not using it:)
 
Did you bench test the monitor in that BZ yet?

~W

Hey walt, Yeah the original monitor in the game was shot.. It needs new amplifiers on the frame.. The 2 5V fuses were bad on the deflection baord. When i replaced them, 2 of the resistors on the board caught FIRE!! I turned the machine off and blew the flame out..lol but i did pin point it to be the amplifiers or whatever those silver things are on the side of the monitor frame, theres like 5-6 of them...


Anyways i just got another go5-802 from a guy down in egg habor that works...

When we test it on kyles astroids the spot light on the deflection is OFF and everything is good, now when i take it and plug it in my BZ the red light spot comes on and i get NOTHING, (this is with boards NOT hooked up)...Now i know the boards are shot cause i see its getting 5v to everywhere it suppose to on the board (test pins) but it doesnt coin up or do anything... Now im not even sure if the audio board works.. The audio might be good and its just the main pcb..theres no way for me to test the audio till i have a working set....

So if the monitor is good, why am i getting the RED LIGHT when i plug it into my BZ??? I check the power brick.. the 10.6V connector on it reads 14.00 is that good?? Also if the power brick is giving to much voltage.. how do i turn it down??? is the tranformer bad on the brick???
 
Last edited:
Hey walt, Yeah the original monitor in the game was shot.. It needs new amplifiers on the frame.. The 2 5V fuses were bad on the deflection baord. When i replaced them, 2 of the resistors on the board caught FIRE!! I turned the machine off and blew the flame out..lol but i did pin point it to be the amplifiers or whatever those silver things are on the side of the monitor frame, theres like 5-6 of them...


Anyways i just got another go5-802 from a guy down in egg habor that works...

When we test it on kyles astroids the spot light on the deflection is OFF and everything is good, now when i take it and plug it in my BZ the red light spot comes on and i get NOTHING, (this is with boards NOT hooked up)...Now i know the boards are shot cause i see its getting 5v to everywhere it suppose to on the board (test pins) but it doesnt coin up or do anything... Now im not even sure if the audio board works.. The audio might be good and its just the main pcb..theres no way for me to test the audio till i have a working set....

So if the monitor is good, why am i getting the RED LIGHT when i plug it into my BZ??? I check the power brick.. the 10.6V connector on it reads 14.00 is that good?? Also if the power brick is giving to much voltage.. how do i turn it down??? is the tranformer bad on the brick???

Why not fix the old monitor instead of replacing it and why not send out the BZ boards to Elektronforge instead of getting new ones ?
 
Back
Top Bottom