WTB Zenith K7000 Remote Board

copyimitation

New member
Joined
Jun 12, 2015
Messages
102
Reaction score
1
Location
Ohio
Rating - 100%
3   0   0
I'm looking for a remote board for a WG K7000 monitor built by Zenith. The remote board says p569.
 
Zenith flybacks are not available.... You know this right....


Well I know they are pretty rare monitors, but I thought the remote board itself might be interchangeable with the non zenith k7000? Or else someone might have a broken monitor and working remote board. My vertical position adjustment knob is broken.
 

Attachments

  • IMG_20170419_112351858.jpg
    IMG_20170419_112351858.jpg
    511.4 KB · Views: 22
Zenith flybacks are not available.... You know this right....
what does that have to do with anything?

Well I know they are pretty rare monitors, but I thought the remote board itself might be interchangeable with the non zenith k7000? Or else someone might have a broken monitor and working remote board. My vertical position adjustment knob is broken.
you could always just replace the pot...should only cost $1 or so plus whatever shipping is if you cant find one locally.
 
I've tried but can't find one to save my life.. I can only find stuff for the non zenith model. My board says P545, but has a sticker over it saying P569. (Pic above)
 
Have you tried Buffett, Ian Kellogg, or security0001? One of them is bound to carry the pot you're after...
 
Last edited:
Well I know they are pretty rare monitors, but I thought the remote board itself might be interchangeable with the non zenith k7000? Or else someone might have a broken monitor and working remote board. My vertical position adjustment knob is broken.

I have one of these boards somewhere in my shop.
If i can find it.. its yours for the cost of shipping sir.
Gimmie til tomorrow night ill look through some boxes.
 
I have one of these boards somewhere in my shop.
If i can find it.. its yours for the cost of shipping sir.
Gimmie til tomorrow night ill look through some boxes.

I will be so grateful if you found this! I just fixed the color on my monitor, and it looks amazing except for the fact that it's up too high and my remote board is screwed. I sincerely appreciate this.
 
i have a assortment of those but need to know value of yours. measure two leads not connected to dial.
 
what does that have to do with anything?

depending if anything else is wrong with it... may not be worth it to keep it in service.


I have a k4600 in my collection... and I will soon sell that sucker off and replace with a g07 since at this time parts are available.
 
i have a assortment of those but need to know value of yours. measure two leads not connected to dial.

Sorry, I don't understand what you are asking me to do. I posted a pic of the board I need. It's on the first page of this thread.
 
Sorry, I don't understand what you are asking me to do. I posted a pic of the board I need. It's on the first page of this thread.

I looked for a good 20 mins and couldnt find it (ill find it when im not looking for it)

What he is saying is,,
each of those dials has a diff ohm value.. they might all look the same but they
act different when adjusted.
If you find out which one is bad,, and tell him which one it is and what the ohm value
of that dial is.. he has replacements.
 
I appreciate you looking for me. If you ever find it, keep me posted. As for the dial. It is the vertical pos knob. I'm not sure how to find out the ohm value...
 

Attachments

  • IMG_20170419_112351858.jpg
    IMG_20170419_112351858.jpg
    511.4 KB · Views: 9
Back
Top Bottom