WTB: This Qbert Part, Can possibly be made?

The Drizzzl

New member
Joined
Nov 12, 2008
Messages
90
Reaction score
0
Location
Reading, Pennsylvania
Rating - 0%
0   0   0
Im down to one last part i need for my qbert. I need one of the sets of wires. Here is a picture of it all. I need the wires that go from the top of the filter board to the inside of the machine. I assume they go to the power source, monitor, and control panel. I figure this can probably be made. Does anyone have one or can anyone make me one?
qbertwiring.jpg
 
technically it can be made but there is a ton of wire in a qbert harness. most will not be willing to make one and if you find someone who will it won't be cheap. look to buy an original from someone. it's your best bet.
 
technically it can be made but there is a ton of wire in a qbert harness. most will not be willing to make one and if you find someone who will it won't be cheap. look to buy an original from someone. it's your best bet.

+1.......... Check Egay. Or post WTB here. Good luck
 
Yeah i wasnt sure if tht was considered the harness or not. Im used to JAMMA so when i started piecing this qbert together and saw all the different wires i was lost.

I've been keeping a good watch on ebay. I posted a want hear about two weeks ago but no response. It's driving me nuts cuz its the last piece i need.
 
Harness

I've got a hacked up qbert harness.. You may be in luck and the part you need won't be a mess.. I need to know the number on each connector to the aux pcb.. Like (J5, or R15) as an example.. Pm me the info and I'll look tonight.
 
Back
Top Bottom