I just got a whole mess of cables in for SH and there are a few duplicates. I'll get them sorted out, cleaned up, and labeled by the end of the weekend.
I just got through pulling all of the spare wiring harness pieces out to the garage where I thoroughly cleaned all of the connectors and the wiring with a damp washcloth and a can of compressed air. It all looks new now.
As I said, I definitely have a duplicate piece or two in the power section of the harness that I'd be happy to part with.
Tomorrow I'll pop open my Spy Hunter cab and start labeling the harness and will see which piece you're missing and if it's one of my duplicates. And I can take a picture of it and post it here too.
So you should be good one way or another by the end of the weekend.
Bad news. Not only did I not get a duplicate of the cables that you're after, I didn't even get *one* as part of my recent wiring harness purchase.
I did get several other duplicate cables but not these.
Here are some pics that I took in case it will help you out. I think there's a 100K limit here so these are sized down. I can email you higher res pictures if you'd like.
Worst case you could buy the connectors and crimp the cables together yourself. If you want to go that route I can give you higher res closeups.
Here's the connector ends on the power board:
And here are the ends that plug into the power brick:
Thanks for taking the pix. Thats exactly what I need!
I know recently people have been parting out SPY HUNTERS, so my hopes are still up! Thanks again.
There was a guy on here with an EDOT that needed a brick. I sold him one with the harness you need still attached. Search the WTB section for someone looking for an EDOT brick and he probably has an extra.