WTB: Sega Eliminator 4P parts

kspiff

Well-known member
Joined
Mar 2, 2003
Messages
17,629
Reaction score
393
Location
Humble, Texas
Rating - 100%
120   0   0
Ok, so to prep for my upcoming (or eventual would be more accurate :/) 4P Eliminator repro project I'm going to need a looot of parts.

Here is what I have obtained so far:

-Repro metal/plastics kit from mjenison
-Test/service/volume assembly

Here is what I anticipate that I will be able to get once reproductions start getting cranked out:

-Repro cabinet (will cut my own with instructions if needed, but hoping these get made)
-Repro panels x4
-Repro CPOs
-Repro boardset
-Repro sound board
-Repro 4P input board (at least I think that was what it was called)

And here is what I anticipate I will have to pick up used/original pieces on:

-Coin doors x4 (w/ coin mechs that have lockout coils if possible)
-4-color Monitor shroud/bezel (hoping this gets reproduced though)
-Monitor (G08 isn't it? Preferably with a nice tube...)
-Transformer assembly
-Power supply board(s)
-Controls to fill out the above panels
-Harness (guessing I'm going to have to make my own, but here's to wishful thinking)

Need to go through mjenison's checklist for these later and edit this list, feel free to chime in if you notice any glaring omissions.
 
@ joemagiera: I can't PM you for some reason, but at any rate I'm not looking to buy a full boardset at this time. Seems like the repro stuff will be cheaper and I like new stuff over old usually. Besides this is going to be a scratch built deal so I'm not too hung up with having original pieces on this project.

Thanks for the offer though, and if you come up with any of the pieces I *don't* have a game plan for (monitor, bezel, coin doors, power supply, transformer assembly) please hit me up again.
 
Back
Top Bottom