WTB Point Blank EMI board Namco v147 EMI PCB

[bimm25i]

Looking to buy a Point Blank NAMCO v147 EMI board. Going to try to get the solenoids in the guns working again. Would need it shipped to Cleveland.

 

[bimm25i]

Bump will buy a whole boardset if youd prefer not to split up

 

[Supergun]

Depending on how much you'd offer, I'd consider selling my entire board set.
PM me if interested.

Main Board:

Gun Board:

Powered up:

 

[bimm25i]

Thank you we might be talking about different things i am looking for this board it would slide onto the jamma edge connector of your pcb. For your sync issue, try jumping a video sync to the pin on J4 on the gun position board in my terrible old picture.

 

[Supergun]

Yeah, I think we might be talking about different things here. Your original post was asking for a "Point Blank" board. (as in Point Blank 1 is what I read it as)

But the above filter board you posted a pic of is for use with Point Blank 2. (at least, I've never seen it used for Point Blank)

 

[bimm25i]

My bad. Yeah im looking for the EMI board. I dont think its actually necessary even for the gun solenoids and start lamps but i am trying to make a cab that is as original as intended as possible. Point Blank 1 and 2 came with them at the very least but it does seem a lot of users have figured out how to make it work just fine without them.

 

[bimm25i]

Bump

 

[bimm25i]

Still hoping to find one of these. Open to buy a PB1 or 2 PCB set that comes with the EMI PCB

 

[DRAGONKZ]

Yeah, I think we might be talking about different things here. Your original post was asking for a "Point Blank" board. (as in Point Blank 1 is what I read it as)

But the above filter board you posted a pic of is for use with Point Blank 2. (at least, I've never seen it used for Point Blank)

Japanese cabinets used the filter board for PB1 (Gun Bullet) as the cabinets are not jamma wired

 

[bimm25i]

Still looking for this

 

[SCUBA King]

I have this.
No way to test as both my PB stacks don't boot.