WTB Outside Frame for Atari Coin Door

Cuda

Well-known member
Joined
Jul 25, 2011
Messages
1,410
Reaction score
169
Location
Olathe, Kansas
Rating - 100%
50   0   1
I just need the outside frame for an Atari Coin Door. If someone has one you can sell me that would be great. I thought I had one but apparently it isn't the right one.

The door I have has almost an 8" hinge, not quite but the frame I have is for a door with about a 7.5" hinge :(
 
Is this an over/under door, "owl eyes" door, etc. Got a pic you can post of the doors guts? I have a bunch of frames.
 
Is this an over/under door, "owl eyes" door, etc. Got a pic you can post of the doors guts? I have a bunch of frames.

I ll get a photo and post it, but nothing that fancy, its out of a Battlezone. So no Owl eyes or nothing, just threw me that the hinge wouldn't work with any of the other coin door frames I had.
 
Coin Door picture

Coin Door picture need frame
 

Attachments

  • coin door.jpg
    coin door.jpg
    326.4 KB · Views: 8
I have this one. The hinge area is approximately 7 7/8". If you blow the pic up, you can read the tape measure. A few chips in the paint on the right hand side around where the cam from the lock. $10 plus shipping
 

Attachments

  • 20180321_140831.jpg
    20180321_140831.jpg
    1.2 MB · Views: 5
I have this one. The hinge area is approximately 7 7/8". If you blow the pic up, you can read the tape measure. A few chips in the paint on the right hand side around where the cam from the lock. $10 plus shipping

This would be helpful and great, PM sent
 
I have this one. The hinge area is approximately 7 7/8". If you blow the pic up, you can read the tape measure. A few chips in the paint on the right hand side around where the cam from the lock. $10 plus shipping

PM me the total and your PayPal address and I will take it

Shipping to 80108

Thanks
 
Back
Top Bottom