WTB: NBA Jam 4 player joystick and button wiring

ph4ntomlord

Active member
Joined
Dec 29, 2011
Messages
518
Reaction score
54
Rating - 100%
27   0   0
Switching my 49-way Blitz joysticks to 8-way, so I can install a 2 in 1 switcher and include NBA Jam....let me know!
 
I am a little confused, are you looking for a Midway kick harness for NBA Jam?
 
I've got a fresh NBA Jam kick harness if your interested.
It's a plug and play and pulled from a functional NBA Jam.
Was looking at $50 shipped for it.
PM me if your interested.
 
The harnesses in my Blitz cabinet are wired for 49 way joysticks, with molex connectors that plug into the I-40 board....where as NBA Jam is wired for 8 ways sticks and has quick connects for the sticks instead of the molex connectors. So I would need all harnesses....1-4player.
 
Let me know then if your interested in the kick harness.
This would be the harness that connects directly to the main board, the 3P/4P harness, the power supply and the coin door.
All's you would need is the control panel harness then.
 
I might have one of these i'll have to look around. (definitely have the kick harness but shawns got ya on that).
 
I think all I need are player 1-4 that go up to the control panel, all the others are there I believe....basically just need the quick connects on the one end of each one. If that makes sense...
 
Hmmm....I'm somewhat new at all this, I'm just wondering how I would go about running NBA Jam and Blitz 99 in the same cabinet via a 2 in 1 switcher....considering my Blitz 99 is wired up to 49 way sticks, and NBA Jam does not support 49 way...??? A little confused...?????
 
pretty sure there's a double male .156/.100 mating header in between the jamma harness and the cp harness, but i could be wrong, that's how so many converted Jam to blitz. you'd just need from the mate and lock to the cp (not sure about the player 3/4 harness, the colors might be different but the wires i think are in the same places (atleast the ones you need)).
 
Back
Top Bottom