WTB Mario bros widebody bezel and Cp

Chris206

Permanently Banned. Dupe account made for fraud. U
Joined
Oct 7, 2008
Messages
866
Reaction score
5
Location
Seattle, Washington
Rating - 100%
57   0   0
WTB Mario bros widebody bezel and Control panel. Just picked a widebody with no bezel and a hacked control panel. let me know what you got!

Chris
 
Just need MB Control panel now!

Biomech hooked me up with a way to get a nice bezel made. I now am just looking for a nice populated or unpopulated control panel. Like I said the one I have has been jammatized. The overlay is non important as it will be replaced! Thanks

Need widebody CP by the way


~Chris
 
I had holes hacked in my widebody cp, I just repaired them and laid a new overlay on it.
I took a page out of jehuie's book. Laid down some steel on the underside-'glued' it on. bondo on the top to fill the extra holes, sanded it down, and done deal.


good luck on the marquee and sounds like you have the bezel. I need both as well for this conversion. I was just going to wait for thisoldgame to make them.
 
Good idea for the CP. It would be nice to have one I could just clean up and put a overlay on. But I'll take your advice and just repair what I have! Thanks Tronguy. Biomech hooked me up with the art file for the widebody bezel I sent it to Rich tonite. I will post pics when it arrives.

Chris
 
But Rich said he may be doing these after he does the marquees......and they would be screened on from what I recall.
 
Yeah you are correct but that will be months away most likely! Id like to get a Bezel in there asap. I can always get Rich's bezel when its available.

~Chris
 
Yeah you are correct but that will be months away most likely! Id like to get a Bezel in there asap. I can always get Rich's bezel when its available.

~Chris

so what are you doing for the bezel? I need one too. Are you getting a cardboard printout and sandwich between two ultrathin pieces of plastic?

If it's possible I'd be down for one to hold me over as well.
 
I am having Rich put the bezel on glass. Solvent Inkjet printed on to 3/16th glass bezel. It should look almost as nice as when he does the silkscreened bezels. Biomech vectorized the art for me! It looks beautiful. He did an awesome job! After Rich gets back to me ill let you know the specifics in a PM


~Chris
 
Back
Top Bottom