WTB Joust Control Panel

nanoryan

Well-known member
Joined
Jun 5, 2006
Messages
1,337
Reaction score
248
Location
Washington
Rating - 100%
7   0   0
Needs to be original and completely populated with harness. Not too concerned about condition. PM me if you have one you want to sell!

Ryan
 
I've got one. I have to go somewhere with the wife, but I'll take a pic when i get back if no one else has gotten you one first...
 
Okay, here ya go. Not perfect, but not terrible. Fully populated, too.

Figure $30 + shipping. I think it cost me about $25 the last time I had to ship one of these. PM me if you're interested...

SDC11213.jpg

SDC11214.jpg

SDC11215.jpg
 
hey modessitt, i don't want to hi-jack this thread, but what is the black thing on the top edge where the cp ends? i'm missing that on my restored cp.

and is that metal support common in williams CPs? needed?
 
hey modessitt, i don't want to hi-jack this thread, but what is the black thing on the top edge where the cp ends? i'm missing that on my restored cp.

It's molding to help seal between the CP and the bezel. Held on by wood staples. You can buy one new for $4 at Arcadeshop:

williams-cp-molding.jpg


is that metal support common in williams CPs? needed?

It was put there on some games to help keep the CP sturdy when people were getting too rowdy. It's just a wood control panel, after all, glued together. I've taken them off when I've done a CP conversion and not had a problem....
 
Back
Top Bottom