jbacon1054
Active member
I am looking for an Irish Millipede lower retainer, part 038805-01. The lower retainer from any Euro Cabaret should work - I think.
It's a U-channel that holds the glass and the cardboard bezel. On the back side of the U is a flange that extends from the top of the U maybe an inch straight out for the full length of the piece; as you guessed, that goes into the slots in those braces on the cab sides. Where that flange sits over the two holes in the CP it has nuts attached - bolts would go up into those from the control panel, keeping it up.
PM if you have one available.
Thanks
It's a U-channel that holds the glass and the cardboard bezel. On the back side of the U is a flange that extends from the top of the U maybe an inch straight out for the full length of the piece; as you guessed, that goes into the slots in those braces on the cab sides. Where that flange sits over the two holes in the CP it has nuts attached - bolts would go up into those from the control panel, keeping it up.
PM if you have one available.
Thanks
Last edited: