WTB: Donkey Kong PCB "wingscrews"

JoeB1355

Well-known member
Joined
Dec 11, 2010
Messages
1,631
Reaction score
99
Location
Seymour, Tennessee
Rating - 100%
45   0   0
I need a pair of the the wingnut with screw kinda things that hold the PCB in. I have the brackets just not screws

Could use a couple nice originals cheap!
 
Last edited:
These are not nuts from what I can tell they are screws with a wingnut looking head

I don't have any or I would try and get a better pic -- I just found that pic on the internet somewhere
 
im almost positive ive seen these types of fasteners at a true value or ace hardware store....may have been a lowes or home depot but thats unlikely..

they are out there..

Josh
 
I checked home depot, but they were stamped wingscrews not the kind with loose head. Also they only had imperial and I'm sure these are metric -- since everything else is

I don't actually have the size either since I don't have one so it would be trial and error

I'll check Lowes -- I think I looked there before
 
Last edited:
whenever i need issing screws or pieces for any arcade machine i go to fastenal. see if you have a local one. they have EVERYTHING. if not they can fabricate some stuff. but they will definitly have what your looking for. i once had a motorcycle i drove into the place so they can replace a few screws.

and seriously you won't be spending anymore then a buck or two. i had to get pieces to put together a deluxe power drift. cost me 58 cents to do the whole thing. best place for these things.
 
I'm still looking for a pair of these -- Its hard to buy them since I don't know size or thread etc -- there should be many of these in the wild though
 
Back
Top Bottom