WTB: CP for Dynamo 19" or 25" cabinet

Mindl3ss

Well-known member
Joined
Apr 17, 2010
Messages
4,208
Reaction score
682
Location
Centralia, Washington
Rating - 100%
24   0   0
Anyone have a cheap CP for a HS-1? 6 button layout would work best.

Non populated is best, I just need it cheap.

PM me with details.
 
Last edited:
Well, it's the HS-1, so it's 28" wide. The CP should be almost 2 inches less than that. I will measure that space a little later and get an exact.
 
Well, I measured, and it was actually 26" wide, so I'm not sure if it is the HS1 now. It looks like one, and has a Dynamo sticker on the back...

Still need a CP for it.
 
Well, did a measurement, and there seems to be about 23 3/4" for the CP.

A search on ebay brings up one they say is 23.88", but they want way too much for it, and would be like swiss cheese by the time I could install a propper button config.
 
I have a lead, but it's not proving to be happening too quickly, so if anyone else can come up with one quickly, let me know.

BUMP
 
I have a cut corner CP that measures 1/16" less than 23 3/4, that is 23 11/16 inches wide. It has the 4 built in bolts at 6 3/4 spacing with hinge. Only has 3 button layout for 2 players but looks too have just enough room to add the other buttons. They would probably have to be offset not directly above/below because the original 3 are in a triangle configuration... so it would look like this...

OOO
.OOO
or
.OOO
OOO

It has buttons but I may take some if you don't need them. I might have joysticks to add and include all the buttons for $25 + shipping or free pickup (know someone traveling the I-5?)

You can have empty for shipping or free pickup in Seattle sometime.
Terry [email protected] email for pics
 
I have a cp from a 25" cabinet its corner cut and has final fight button layout. I will give you that for $25 shipped when i dig it outta storage. I am turning my 25" machine into a street fighter and already bought a cp for that. let me see if i can get pics and what not
 
I found one with the three button layout for the 19" cab. I still wouldn't mind one already drilled for six buttons, but since I already have one, it would have to be super cheap.

I have one for the 25" cab as well, but again... it looks like swiss cheese. If I had one set up for 6 buttons, I would be game for it.
 
Back
Top Bottom