WTB - Atari System 2 lower bezel bracket

I dug through all my brackets and it wasn't in there. I will however be listing what I did find for sale soon
 
Last edited:
mine is exactly 23-11/16" long, then its from top down 2-13/16" to the center of the bend, another 5/8" from that point to the bottom of piece

bend is right around 110 degrees
 
couple pic's for reference - excuse the lack of quality hopefully gets the point across tho

guessing if it was completely flat ... before bending it, it would measure a hair over 3-1/2"

micrometer says it is 16ga steel
 

Attachments

  • DSC_6131.jpg
    DSC_6131.jpg
    447.7 KB · Views: 17
  • DSC_6134.jpg
    DSC_6134.jpg
    405 KB · Views: 16
  • DSC_6135.jpg
    DSC_6135.jpg
    496.9 KB · Views: 18
  • DSC_6139.jpg
    DSC_6139.jpg
    278.8 KB · Views: 18
  • DSC_6141.jpg
    DSC_6141.jpg
    347 KB · Views: 16
apparently I am need of one of these also, I happen to have one to reference...I'm going to a local shop and will have a few made, won't be original but it will look right and get the job done, can I assume you would want one... I'm hoping they won't be particularly expensive since it's pretty simple... if you want it powder coated too I have a friend that can handle that as well
 
Back
Top Bottom