WTB: Arachnid super 6 dart board parts

cysnake

Well-known member

Donor 2018
Joined
Sep 25, 2005
Messages
6,273
Reaction score
743
Location
Pennsylvania
Rating - 100%
61   0   0
Im in need of pretty much everything. I need boards, wiring harness, monitor, dart head segments, possibly more. I have a matrix and dart head, but im missing some segments. Ideally would like a super 6 plus II board, but will take either.
 
I had a few of these at the same time earlier this year, they're all gone but I still have a board.

I tagged it "working" but not accepting coins, I didn't spend any time troubleshooting it.

If you could use it, I'd sell it for $20 including shipping via Priority Mail. My Paypal address is: [email protected] and I'd get it on the way right away.

Let me know,
Mike Doyle
 
i have a board that was tested working 2 years ago. Theres one chip with a chunk missing out of it but i swear it still worked! (worst case replace the chip) IIRC Its the older type that iirc didnt require the seperate credit board that the older ones did.

I also have a single bull darthead with all segments... i might have other odds and ends like lamp sockets.. I dont remember if i still have the wiring or not..
i also know i have a manual, some league papers, and some old service bulletins from arachnid as well...


back in the day i had two machines and i bought a beatup working but monitorless machine for parts... so thats how i got the stuff.

you will want to test your power supply before you plug in boards... they lose +12 alot due to bad rectifier and or trace issues/solder issues at the connection to the rectifier. make sure your rectifier has a heat aink attached. and sometimes the +5 regulator will short and pump up to 14 volts into the +5 and cook your new board!! so check it out on mone i also added a 12v pc fan near the ps to help it run cooler...
 
Last edited:
Back
Top Bottom