WTB- 4 switch 8 pin right angle dip switch

That was what was on the pcb, it was right at the edge of the board, not a lot of room. It sat sideways instead of flat. Came off a GT99 I believe.

Toby
 
Is there enough room for a standard dip switch? I have plenty of those.
I have some 90° ones around somewhere but only god knows where they are at.
 
The pads are really close together. I think a standard dip legs are too far apart. Think I could run wire from the pad and have a kinda remote board dip? Then I could use a standard dip.

Thanks
 
Let me look through all my bins as a last resort. I know I have a few right angle dips, not sure how many position they are. Maybe we will get lucky....it might be like finding a needle in a haystack.
 
Back
Top Bottom