Williams Firepower

smisch

Member
Joined
Jan 12, 2010
Messages
808
Reaction score
7
Location
clinton twp., Michigan
I have a question.

Dip switch settings? There are two on the sound board sw2-on, sw1-off correct?

There are two banks on the mpu, the lower one states it does not get used so all off. The upper one is a bit cloudy? 6,7,8 are they on or off? The book is not clear on this.

Thanks
 
Dip switches are almost never used in Firepower, they're more for compatibility with very early System 3 games that used them for various settings.

Just leave all the CPU board dip switches set to off. Sound card switches sound correct to me as well.

-Hans
 
Firepower

THanks,

I have been to that site, seen the settings for resetting. Wasn't sure if you leave them on or off?

Thanks for the help, getting closer to being 100%
 
Firepower

Thanks for the info, shes up and running with all sounds. Have a couple issues

Left ball trap will not kick out ball, solenoid works in test mode

Top left spinner makes no sound when ball goes trough, should make the Robotron sound.

Lastly the ball return will not kick a ball to the right when it gets past flippers, again solenoid does work in test mode.

Leaf switch issue??? Not much in the manual about it

Thanks again
 
Most likely switch issues all around. Those are all on column 1, so test all the switches in that column and see if it's individual switches or a dead column.

-Hans
 
Back
Top Bottom