Will a wide body pin and a Stargate fit in a short bed truck?

redlines

Member
Joined
Aug 5, 2009
Messages
74
Reaction score
3
Location
Novato, California
Will a wide body pin and a Stargate fit in a short bed truck?

I am getting a widebody pin and a Stargate tomorrow. I have a 2000 tundra short bed and was wondering if I can fit them both or will I have to stack the pin on top of the stargate? Looks like I would have to put the stargate on its side and the put the pin on top of that, strap it down and hope for the best. Any suggestions?
Thanks
 
You can drop the head of the pin, pull the legs, and stand it up on end. It is how they were designed to be transported. I am certain that you could then fit both in your truck.
 
Ok thanks. I knew I could drop the head and strip the legs but I wasn't sure you could stand it on up like that and not break anything during transport.
 
If you look at the back of the cab there are usually four nylon feet for standing the cab up on. Of course, you should remove all loose articles from the machine before standing it up. This includes the coin box and anything under the palyfield. It is also a very good idea to pull the balls as well.
 
Back
Top Bottom