where does this red plastic mini-post go on TAF?

elfyhead

New member
Joined
Aug 14, 2010
Messages
697
Reaction score
6
Location
New Mexico
after a complete tear-down, clean/wax, and then rebuild of my TAF, i have a single post that i don't know where it goes. it's one of the red plastic mini-posts, shown in the first attached pic. i have three of them already on the p/f, in the locations shown in the other three attached pics, but where does the fourth go?

i've looked at my pre-tear-down pics, and at other high-res pics on the interwebz, and can't for the life of me find where that fourth one goes :|...
 

Attachments

  • post1.jpg
    post1.jpg
    57.9 KB · Views: 13
  • post2.jpg
    post2.jpg
    75.1 KB · Views: 25
  • post3.jpg
    post3.jpg
    91.3 KB · Views: 24
  • post4.jpg
    post4.jpg
    80 KB · Views: 26
after a complete tear-down, clean/wax, and then rebuild of my TAF, i have a single post that i don't know where it goes. it's one of the red plastic mini-posts, shown in the first attached pic. i have three of them already on the p/f, in the locations shown in the other three attached pics, but where does the fourth go?

i've looked at my pre-tear-down pics, and at other high-res pics on the interwebz, and can't for the life of me find where that fourth one goes :|...

The fourth one goes on the dark blue plastic at the top left corner of the playfield. Not really visible when everything is all assembled, and I'm not really sure what the purpose of it is.

Phil
 
whats up with the solder on the red wire behind the 2 blue targets ?

looks like its cracked and needs attention
 
The fourth one goes on the dark blue plastic at the top left corner of the playfield. Not really visible when everything is all assembled, and I'm not really sure what the purpose of it is.

Phil

thanks! i had forgotten about that one, and didn't have a good pic of the area.

i had heard lots of folks saying "take lots of pictures during the tear down" here on the forum, so i did just that - i think i took 300 or so. but it's amazing that there were still a few that i wished i had taken after the fact from slightly different angles, or after a particular piece had been removed, etc. ah well - at least i only ended up with that one mini-post that i didn't know where it was :)...
 
whats up with the solder on the red wire behind the 2 blue targets ?

looks like its cracked and needs attention

hmmm, dunno. i'll have a look. all the switches are working, etc., but i may have to reflow that connection...
 
Back
Top Bottom