Where does the external PCA go for Ms Pacman? also need info for a fan *pic

infinkc

New member
Joined
Mar 1, 2011
Messages
64
Reaction score
0
Location
Elk Grove, California
Where does the external PCA go for Ms Pacman? also need info for a fan *pic

Can seem to find where the external PCA goes inside the cabinet, when i got the thing it was just loose and i found the screws for it. Anyone have a picture were it should go?

Also i noticed the fan is not working, is this fan anything special? 12vdc? 120vac? where can i get a replacement. It will start to spin but then dies out.

pcad.jpg
 
Not sure where the board goes - but you can get replacement fans at twobits.com.

They are exactly the same -- same plug, same fan grill as the original. Put one in my old pac cocktail and it worked fine.
 
It may never have been mounted. Mark, drill pilot holes, and secure it to the wood side so that the ribbon cable has slack.
 
cant figure out where it may have been mounted to, i dont see any screw holes in the wood that line up.

Looks like it usually would've been mounted the front, next to the coin door, so it would've been parallel to the main PCB - see attached pic from the manual.

Although perhaps as smalltownguy2 says, if you don't see mounting holes there yours may not have been mounted at all.
 

Attachments

  • mspacpcb.jpg
    mspacpcb.jpg
    88.7 KB · Views: 18
Back
Top Bottom