Museum of the Game® & International Arcade Museum® Forums

I bought this off ebay a long time ago. It's been a good monitor in my Gorf on location for years. The red gun was shorting, so I quick swapped in a K4700. I ran a clean and balance on the bench and the red gun is now fixed. I noticed these squiggly lines and no adjustment could take it out. This was advertised as having been recapped, but the B+ was not replaced. The B+ voltage is 125v and I don't have a new pot on hand. 25% of the time these end up breaking no matter how careful I am removing the glue.

Is this caused by the old B+ cap or the +2v? Or something else?

1000002603.jpg
Back
Top Bottom