What a Dumb Ass

Phetishboy

Well-known member
Joined
Dec 12, 2006
Messages
47,929
Reaction score
9,392
Location
Avon, Minnesota
I went to install my newly constructed Ninty Mullet into my DK3 cab and stuck the mounting tape to the back of it rather than to the top. Couldn't get the mounting tape off the back without ripping it, so I had to cut an inch wide strip of black poster paper to cover the mounting tape strip and render it's dust/debris collecting powers benign. Lesson: Take your time and be sure of what you are about to do before just doing it. Loser.
 
I just about punched holes upside down for the MW CP I'm building. Seriously - don;t talk to someone on the phone or in person when you're working either ;)
BTW Phet pics are needed - you might just be the new NOICE lol
 
I went to install my newly constructed Ninty Mullet into my DK3 cab and stuck the mounting tape to the back of it rather than to the top. Couldn't get the mounting tape off the back without ripping it, so I had to cut an inch wide strip of black poster paper to cover the mounting tape strip and render it's dust/debris collecting powers benign. Lesson: Take your time and be sure of what you are about to do before just doing it. Loser.

If you can't see it once it's installed - it didn't happen.

RM
 
It must be something going around because the other day I came really close to
welding up the wrong holes in my MB wide CP. I had the welder on, slugs in place just getting ready to flip my mask down and decided to double check if it was right. Needless to say, it was not. I usually never rush but I did that time and almost paid the price.
 
If you can't see it once it's installed - it didn't happen.

RM

Well you can if you:

remove the back door, bend over and look up.

Incidentally, these are the very same instructions Frizzy gives at about 3am for every all-guy slumber party he throws at Boysticks.
 
I went to install my newly constructed Ninty Mullet into my DK3 cab and stuck the mounting tape to the back of it rather than to the top. Couldn't get the mounting tape off the back without ripping it, so I had to cut an inch wide strip of black poster paper to cover the mounting tape strip and render it's dust/debris collecting powers benign. Lesson: Take your time and be sure of what you are about to do before just doing it. Loser.


You most certainly are a loser and a dumb ass. Come to think of it, you're a stupid f***er too. Have a good weekend my love, we'll see you in a couple weeks or less.
 
Last edited:
I hate it when I think I'm being really clever and using a ruler to mark and align holes in a control panel, and then drill the pilot holes. That's usually when I figure out that I had the damn thing upside down and now I have little holes drilled in my CP in the wrong places....
 
I went to install my newly constructed Ninty Mullet into my DK3 cab and stuck the mounting tape to the back of it rather than to the top. Couldn't get the mounting tape off the back without ripping it, so I had to cut an inch wide strip of black poster paper to cover the mounting tape strip and render it's dust/debris collecting powers benign. Lesson: Take your time and be sure of what you are about to do before just doing it. Loser.

Remember, it's cut twice measure once... No wait! :D
 
At least you didn't plug the board in backwards. I am still bummed that I did that to my Atari Football.
 
Back
Top Bottom