tb lilley
Member
I've been searching for an Atari colour vector power supply with no luck, so it's time to go a bit Heath Robinson. I've a spare Atari raster power brick (Centipede cabaret) that'll give me most of the voltages I need. But I'll be short of the 50V AC CT for the 6100. But I'm fairly confident that I can splice one of these into the brick:
This gives 48V AC CT, which falls slightly short.
However, the 6100 manual indicates that it'll run with up to 15% less:
So I should be good to go.
Only one question - 6100 manual suggests input power requirement of 150 watts. Any idea if the transformer above will meet that?
This gives 48V AC CT, which falls slightly short.
However, the 6100 manual indicates that it'll run with up to 15% less:
So I should be good to go.
Only one question - 6100 manual suggests input power requirement of 150 watts. Any idea if the transformer above will meet that?

