WG4600 bad horizontal hold?

thairoller

Member
Joined
Aug 25, 2010
Messages
150
Reaction score
1
Location
California
Just finished a capkit on this chasis and i can't seem to dial in the h-hold. The picture looks like the attached photo when the pot is at it's extreme positions and garbled in the middle. Vertical hold is fine. B+ 131. I re-flowed the solder at the daughter card connections during the cap kit. Not sure if this issue has preset before the cap kit because the picture was much worse. need a new pot? Any suggestions?

http://imageshack.us/photo/my-images/441/22356825.jpg/


Also, the focus on the flyback doesn't seem to do much at all.

Thanks for any input.
 
Back
Top Bottom