Just refurbed a V2000 to put in an Asteroids. The Asteroids I have both had GO5s in them, so I got a GO5 to V2000 harness from Mr. Roberts.
Fired it up, and the pic is real good, except it is mirrored, as in if I hold a mirror facing the monitor, the mirror is correct.
BUT, interestingly, the Rotate Left and Rotate Right are also backwards!
So I pulled the V2000, put a GO5 back in it, and it is fine, controls and all.
I have researched mirrored images on here, and have seen some stuff on swapping yoke wires, but would they also make the buttons backwards?
I have burn eveidence that the V2000 was used in a verticle orientation before I got it, but don't think that has any bearing on this?
Could it be the harness?
Fired it up, and the pic is real good, except it is mirrored, as in if I hold a mirror facing the monitor, the mirror is correct.
BUT, interestingly, the Rotate Left and Rotate Right are also backwards!
So I pulled the V2000, put a GO5 back in it, and it is fine, controls and all.
I have researched mirrored images on here, and have seen some stuff on swapping yoke wires, but would they also make the buttons backwards?
I have burn eveidence that the V2000 was used in a verticle orientation before I got it, but don't think that has any bearing on this?
Could it be the harness?
