WG K7689 position issue post cap kit and yoke swap

75ohm

New member
Joined
Aug 25, 2008
Messages
344
Reaction score
1
Location
Tampa, Florida
Long story short, nice tube, yoke smoked and was swapped and a cap kit done on the chassis.

Vertical orientation and the image is far from centered (too high) on the display... while adjusting the pot on the remote board, you turn a lot to adjust the image just a little and then it jumps down to where it needs to be and holds. Great, so I thought...

Power off the game and when you turn it back on, you do the same thing again. Doesn't matter how far you adjust the pot back to the original setting, you've got to adjust, wait for it to jump down, then adjust.

All in all, great image though...

Any thoughts on this? Thanks...
 
Back
Top Bottom