Wg k7000 25 iso transformer question

78whiteorbs

Well-known member
Joined
May 3, 2021
Messages
1,721
Reaction score
787
Location
North Carolina
Got a Atari Maximum Force I think has a bad monitor (neotec nt-2515) not showing a vid signal. Same as if I disconnect rgb and sync wires on display.....


I have a great 25 k7000 standard res I can put in there but says MUST USE ISO transformer on power connecter for the wg.

I was mainly wanting to test and make sure I'm not having a video out issue from the board. Can I do this without bad things happening?
 
If the chassis says it needs a isolation transformer, then you shouldn't plug it in without one. Your cab may already have one; check the bottom of the cab and confirm that the AC wiring that goes to the chassis is coming off the transformer.
 
Area 51 and Maximum Force did not come with isolation transformers. if you're running a K7000 without one, don't connect earth ground. and most importantly, buy a transformer. you can power it off the 3 pin AC accessory plug of the power supply.
 
Area 51 and Maximum Force did not come with isolation transformers. if you're running a K7000 without one, don't connect earth ground. and most importantly, buy a transformer. you can power it off the 3 pin AC accessory plug of the power supply.
Yeah, that's exactly what I did.And use the isolation transformer that was used with the cab I pulled in from works great and safe.
 
Back
Top Bottom