SOLD - PARTS WG K4600 complete monitor and chassis

i86time

Well-known member
Joined
Apr 3, 2011
Messages
2,257
Reaction score
410
Location
Riverside, California
Rating - 100%
53   0   0
I have a couple K4600s for sale.

The first is a working WG K4600 complete monitor. This chassis was capped about 4 years ago. The tube has mild Centipede burn but it is hardly noticeable with an image displayed. The interface card accepts both positive and negative sync. Asking $90.

All Sold
 

Attachments

  • DSCF8168s.jpg
    DSCF8168s.jpg
    259.2 KB · Views: 45
  • DSCF8162s.jpg
    DSCF8162s.jpg
    243.4 KB · Views: 34
  • DSCF8163s.jpg
    DSCF8163s.jpg
    347.9 KB · Views: 37
  • DSCF8170s.jpg
    DSCF8170s.jpg
    449.6 KB · Views: 44
  • DSCF8172s.jpg
    DSCF8172s.jpg
    475.3 KB · Views: 38
Last edited:
Next up is a semi-working K4600 chassis. The main chassis and the interface card (P297, negative composite input only) work fine. The X-Y horizontal/vertical card had a large crack that was repaired (not my prettiest work), and it displays an image but it doesn't always want to hold vertical sync and it has a vertical bend in the image (see photo). This chassis has not been capped, so perhaps that will help, but I cannot say that it will remedy the issue fully. I did verify the issue is with the X-Y card as when another working card was switched in, the image was stable. Additionally the width coil tube has been cracked at one end and the slug inside is seized. The chassis is complete with the neckboard and flyback. Asking $60 shipped CONUS.

SOLD
 

Attachments

  • DSCF8153s.jpg
    DSCF8153s.jpg
    278.7 KB · Views: 33
  • DSCF8154s.jpg
    DSCF8154s.jpg
    450.3 KB · Views: 36
  • DSCF8155s.jpg
    DSCF8155s.jpg
    332.3 KB · Views: 27
  • DSCF8156s.jpg
    DSCF8156s.jpg
    314.4 KB · Views: 23
  • DSCF8158s.jpg
    DSCF8158s.jpg
    501.3 KB · Views: 24
Last edited:
This was bothering me, so I hooked up another pattern generator and it filled the screen. Then I hooked it to my Stargate and that image filled the screen. So it looks like there's no issue with the monitor (other than it doesn't like the TPG output)
 

Attachments

  • DSCF8175s.jpg
    DSCF8175s.jpg
    323.4 KB · Views: 18
  • DSCF8174s.jpg
    DSCF8174s.jpg
    317.3 KB · Views: 25
Back
Top Bottom