I have a d9500 I'm trying to hook up to a millipede.
No matter what I try, the monitor shows an "out of range" error displayed on the screen.
Behind the error I can see millipede (barely).
Is there a setting I need to set on this monitor? Or is it simply not compatible?
Thanks!
EDIT: I should say that the cables I have plugged in are R G B Gnd VSync HSync
No matter what I try, the monitor shows an "out of range" error displayed on the screen.
Behind the error I can see millipede (barely).
Is there a setting I need to set on this monitor? Or is it simply not compatible?
Thanks!
EDIT: I should say that the cables I have plugged in are R G B Gnd VSync HSync
Last edited:
