Wells Gardner D9400 Horizontal size issue

Redact

Member
Joined
Jan 29, 2015
Messages
77
Reaction score
13
Location
Texas
I have a D9400 that does not fit the screen. When I adjust the pot on the board to max I still have about 2" on both sides of the screen. I have gone into the menu and tried to make it bigger but no change. It will shrink just not expand.

Is there a setting somewhere that tells the board that this monitor is 25" instead of 27"?

I'm not sure where to go on this any help would be great!!

Thank you!
 
Is this vertically or horizontally that you have a gap.

If the horizontal width coil doesn't get the picture wide enough if your monitor is mounted horizontal then it may be possible to change the width cap.. , if the picture is not tall enough to fill screen and monitor is mounted vertically then its same issue.

Mine was a 4900 19in vertically and I used this kit

 
I have installed a new cap kit into the chassis. The vertical will fill the screen but the horizontal will not fill the screen.20240902_142405.jpg
 
Can anyone point me to the width cap on this chassis? After watching different videos I agree that's my problem now I just need to replace it.

Thanks again for all the help!!!
 
Back
Top Bottom