Wanted: NOS Tempest Spinner Knob

Daviea

Permanently Banned - See: Ram Controls Forum Secti
Joined
Jul 18, 2006
Messages
958
Reaction score
8
Location
Huntington Beach, California
Rating - 85.4%
82   14   0
I've been working on reproduction parts non-stop these last few weeks. I was drawing up the Tempest spinner knob a few minutes ago and realized that I am copying from a previous reproduction version made by an unknown source. It only has one set screw. This is an unacceptable part for me to work from, so I'm on the hunt for an OEM spinner knob, hopefully in NOS condition.

Here's the part I have it drawn up so far:

spinnerknob01.jpg


spinnerknob02.jpg



It's incomplete, awaiting some final dims from an OEM part. What you see is about 5 minutes of work....

Also, anyone ever apply surface texture in solidworks? Looking for some direction on that topic.

Thanks

Dave
 
Last edited:
I've been working on reproduction parts non-stop these last few weeks. I was drawing up the Tempest spinner knob a few minutes ago and realized that I am copying from a previous reproduction version made by an unknown source. It only has one set screw. This is an unacceptable part for me to work from, so I'm on the hunt for an OEM spinner knob, hopefully in NOS condition.

Here's the part I have it drawn up so far:

spinnerknob01.jpg


spinnerknob02.jpg



It's incomplete, awaiting some final dims from an OEM part. What you see is about 5 minutes of work....

Also, anyone ever apply surface texture in solidworks? Looking for some direction on that topic.

Thanks

Dave

I've got an NOS one if you still need it.

Edward
 
Spinner

I have a couple of them that were sold to me as NOS but I dont remember if they have 1 or 2 set screws. I will have to look. If they are, you are welcome to 1 of them.
 
Back
Top Bottom