Wanted NOS RB tapper CPO and art

Status
Not open for further replies.

fizgig

Permanently Banned for constant cyber bullying. Ge
Joined
Aug 14, 2010
Messages
5,869
Reaction score
61
Location
Murrieta, California
Rating - 100%
58   0   0
Looking for NOS control panel overlay, bezel, marquee and side art for a root beer tapper.

Thanks
Dan
 
Ive done the RB tapper cpos for Anthony over @QuarterARcade
and shold be avaiable soon. sending him out for a test fit this week.
Ive also got the sideart done but needs so color correction before splicing it in with the previous tapper/timber sideart Ive done.
so should have them ready about the same time later in the month.
 
So cool!!!!!! Can't wait.


Ive done the RB tapper cpos for Anthony over @QuarterARcade
and shold be avaiable soon. sending him out for a test fit this week.
Ive also got the sideart done but needs so color correction before splicing it in with the previous tapper/timber sideart Ive done.
so should have them ready about the same time later in the month.
 
Project has hit a snag :(
intially the thought was to take the work I did to the Tapper cpo which was done from an NOS piece then extend it out on each end about an 1" or so to make the fit for RB.
sent samples to Anthony and apparently RB used a different wood grain alltogethr.

This is problematic since finding a NOS RB will be pretty tough and to scan, and recreated again from a panel would be just as hard.

waiting for some comparison pics from Anthony
 
Hmm, how different is the grain? Probably still look really good even if it's not true to the original.

Gary, I could check out the CP you have and see if i could carefully remove it. I've done it a few times.

Project has hit a snag :(
intially the thought was to take the work I did to the Tapper cpo which was done from an NOS piece then extend it out on each end about an 1" or so to make the fit for RB.
sent samples to Anthony and apparently RB used a different wood grain alltogethr.

This is problematic since finding a NOS RB will be pretty tough and to scan, and recreated again from a panel would be just as hard.

waiting for some comparison pics from Anthony
 
Im really not sure how different it is
Anthony said he was going to send me pics to show me.
but havnt seen it yet.

screening Tapper was no easy task, color sperations, color matching, halftones, etc.
and some had to wait 100 days to get the final version :D
 
Status
Not open for further replies.
Back
Top Bottom