WANTED: Elvira Party Monster Ramp(s) - HELP

did you try

hi did you try Pinball Inc he was just to the ohio show had a ton of new ramps he is out of atlanta georgia.
 
No luck here, I tried him - no answer yet.... But I do not see any on his website.

Thank you for the suggestion.

I dont think James makes these ramps yet...If there is enough interest in them, im sure he would consider it
 
Found them.... 1 at Bay Area, 2 at Mr. Pinball Australia (aka Wayno).

$650 later!!!!! (shipping / duty) Ouch!

Funny thing is I bough a project machine for $1050 and after going through it, had to also buy $1500 worth of parts.... (The ramps and cab decals were $1000 alone!) I guess that's what out of stock parts cost... PREMIUM!

Oh well, at least when I'm done I'll have a 10/10 EATPM machine.... not too many of them around (being 10/10 condition that is.)

PS: If anyone wants some old used parts I will sell them cheap. Also selling a use translite that is in pretty nice condition - (just not perfect enough for my machine - with the $$$ I'm putting into it)
 
Funny thing is I bough a project machine for $1050 and after going through it, had to also buy $1500 worth of parts.... (The ramps and cab decals were $1000 alone!) I guess that's what out of stock parts cost... PREMIUM!

This is the main reason you research available parts before buying a project. However, if you plan on keeping it, then the money doesn't matter.
 
Back
Top Bottom