W/G K7000 heating up R96?

shawnbo42

Member
Joined
Mar 8, 2009
Messages
343
Reaction score
4
Location
WATERFORD, Connecticut
Anybody ever seen this before? I had a k7000 with no pic. Long story short, I've changed the fly, voltage reg, 2 power supply caps (near the fuse), 2 of the mylars near the yoke connector, checked the yoke connector, chacked a bunch of crap on the board itself, etc. Now, the problem. Turn the game on, I can hear HV through the tube. I get no neck glow whatsoever. After about 30 seconds or so, R96 gets red-hot and stays that way. I have NO ideas on this one...anybody?
 
Measure the resistance on the Horizontal Yoke winding. (unplug the yoke, measure the red/blue)

Measure the B+ voltage. (DC voltage, should be about 123v if 19"...130v if 25")

Check C38 for short.

Check that Horizontal Position jumper is in place.
 
Back
Top Bottom