mrbill2084
Well-known member
An op I know bought 4 of these like 4 years ago and I put them in his ms pacs for his route.
well, this was the 1st one to die. I was in his noisy/hot laundromat location, but I think I heard HV for a second and no pic. It was too bright to see neck glow. I have never messed with vison pro other than installling these 4. I just temp swapped it back to a g07.
Are the mtg-1901cn starting to fail? What usually goes? It would be nice to get a spare chassis so next time I don't have to pull the monitor. I assume there are no new chassis that can be purchased..
I was just thinking the 1st monitor to fail was the wells 7400(last 24.8" monitor wells sold on their site). that one appears to work, when out of the cab, but shoving it back into a the red angle cab it shuts off after a few hours. I think its poor air flow in the cab..
well, this was the 1st one to die. I was in his noisy/hot laundromat location, but I think I heard HV for a second and no pic. It was too bright to see neck glow. I have never messed with vison pro other than installling these 4. I just temp swapped it back to a g07.
Are the mtg-1901cn starting to fail? What usually goes? It would be nice to get a spare chassis so next time I don't have to pull the monitor. I assume there are no new chassis that can be purchased..
I was just thinking the 1st monitor to fail was the wells 7400(last 24.8" monitor wells sold on their site). that one appears to work, when out of the cab, but shoving it back into a the red angle cab it shuts off after a few hours. I think its poor air flow in the cab..
Last edited: