Vision Pro in a MCR (Timber)

HighScoreSaves

Well-known member

Donor 7 years: 2013-2019
Joined
Mar 23, 2007
Messages
15,831
Reaction score
757
Location
Blaine, Minnesota
I have a quick question.

Installed a VP in a Timber. Picture looks great, however, it seems that I cannot move the image to the right.

It has a daughter board, used all the adjustments, still no go.

Is there a jumper on this to shift it to the right?

Thanks in advance!
 
Without showing me a pic of what you are talking about, i can't be sure, but try pushing the little white button on the chassis to see if that helps...
 
No. It's a sync select button to switch the signal between negative and positive sync, so that if you put the monitor in a cab that only has a 6-pin connector - with either positive sync or a composite negative sync for those monitors that are sync-sensing - you can route the signal to where it needs to be. Yours was in the wrong position for the Timber connector...
 
Back
Top Bottom