VGA converter problem

gabesdad1981

New member
Joined
Jun 10, 2010
Messages
1,598
Reaction score
7
Location
Daniels, West Virginia
so I am putting together one of the table top tatio classics and I am using a nice little free 15 inch lcd monitor....I hooked it all up and it comes up on monitor analog and says can't display this mode...
any ideas? The red green blue ground and sync from the jamma are all hooked up to the corresponding wires on the converter right below the monitor in plug.

there is another set of wires for video on the be but one of the wires is grey so I didn't use that set up..
the converter is from paradise arcade btw..
 
Last edited:
The one I bought from them has multiple modes. There is a button on the board to change modes. It remembers the last one. Also, there are two video inputs on the board and I think maybe a switch or jumper to change between them. The manual for the one I bought from them is available for download from their website. When changing modes, give it a couple of seconds to see if the monitor will sync.
 
Back
Top Bottom