vector tube question

shocks

New member
Joined
Sep 18, 2017
Messages
4
Reaction score
0
Location
Durham, United Kingdom
Hi all apologies if I'm asking a question that has been asked before but I did a search and couldn't find what I was after.

I'm looking for a list of comparable tubes to use with Amplifone deflection and hv pcb set up, and obviously rewind the Yoke. Basically I only have tempest board at the moment and am going to build up a custom cab.

Some burn free tubes I found below any of these compatible?

20" HANTAREX POLO

15" Eurocoin KTH-F tube

20" WELLS GARDENER TUBE CRT R510CK1CA1C-TC06 A48JLL40X06



any help gratefully appreciated.

Thanks

Steve
 
If you are winding your own yoke, then 'any' tube should do. If you doing a 19" Amplifone and can aquire a yoke, then a 90 degree tube with the larger neck (except Sony I hear and maybe a few others) should work. (There are some other compatability factors, such as grid 2 voltage, etc more than likely.... but I believe many would work).

19" Amplifones use 90 degree tubes
WG6100 uses a 100 degree tube
25" Amplifone uses a 100 degree tube (and the same yoke I believe as the WG6100)
Electrohome G08 uses a 100 degree tube

More can comment further. I haven't done this myself, but I have enough parts to put together a 19" Amplifone (minus frame) from a TV tube and 19" Amplifone parts I've had kicking around for years.... I just haven't gotten to it yet.
 
Back
Top Bottom