Using mk 2 and umk3 in a mk 4 can

DKJR

New member
Joined
Apr 20, 2009
Messages
1,280
Reaction score
8
Location
Iowa City, Iowa
So looking for step by step instruction on play these two pcbs in a mk4 or mk3 can. I've read easy plug and play I've also read you need a extra kick harness and a audio board mk2 issue or plug in? Just confused any instruction will help
 
So looking for step by step instruction on play these two pcbs in a mk4 or mk3 can. I've read easy plug and play I've also read you need a extra kick harness and a audio board mk2 issue or plug in? Just confused any instruction will help

Detailed instructions? I can make a video for you. It would be much easier. Give me a few minutes.
 
Let me know if this helps. If you are looking play them both without physically swapping boards, that's a whole other ballgame. Let me know if this is not what you mean. Assuming that you have a complete MK2 board set (sound board, ribbon cable, and power cables) then just changing the Jamma connector and the Player 3 harness described below is all you'd need to do...


 
Last edited:
This was perfect I wish everyone could be as friendly and helpful. Im a very visual learner and reading stuff doesnt always do the trick thanks a million.
Tony
 
This was perfect I wish everyone could be as friendly and helpful. Im a very visual learner and reading stuff doesnt always do the trick thanks a million.
Tony

Zenomorp is top notch. Before I knew who he was on KLOV, I contacted him through his YouTube account to inquire about a Z-Bracket for an MK project. He then sold me one off his game and told me he would make another. A+ guy.
 
Zenomorp is top notch. Before I knew who he was on KLOV, I contacted him through his YouTube account to inquire about a Z-Bracket for an MK project. He then sold me one off his game and told me he would make another. A+ guy.

Yes, I remember. Glad I could help.
 
Back
Top Bottom