Current state. See pics.
At this point, I have pretty much put everything back that I have. Now for the harder parts.
Here are the next steps:
1. Build a completely new back door system. Everything was missing. This is a four-part set. Two parts are fixed. Two are removable. Again, I built a new upper removable section for my Devil Zone. This is not going to be too hard. The trickiest part will be the handhold in the middle fixed section and the circular cutout on the bottom of these games where the power cord enters. All my issues here will have to do with my lack of a real woodworking area/setup (aka need good driveway weather).
2. Figure out T-molding. A separate thread going on for this. Need 27/32" black T-molding.
3. Need power supply AND transformer.
@TSB - I assume at this point your power supply stuff is staying with you. Right now I am actually most interested in the transformer setup. I might be forced to go to Facebook groups....
4. Artwork - I have scans of the two bezels. I want to work with
@Solodus from RetroCity Arcade on this. The key point will be to figure out if I want the lower bezel printed on glass. Ideally, it would be. I don't know if he can handle that. I love TOG quality but I am not sure I can do the wait associated with full custom.
@advans13 - what is your thread turning up regarding good custom printing options?
5. Speaker - just need to get a simple speaker. I need to look at what my other Universal games have. Easiest next step.
Anyway, that is good for now. There is a whole discussion to be had on the monitor, shroud setup, monitor support, PCB, wiring, etc.
If you have parts PM me!