You are using an out of date browser. It may not display this or other websites correctly. You should upgrade or use an alternative browser.
Museum of the Game® & International Arcade Museum® Forums
I have a u5000 and when I try to adjust the height to fill the bottom inch or so of the screen i seem to be getting fold over. If I reduce the height i get a good picture.
It has a new cap kit. I have checked everything it list out of circuit in the trouble shooting sheet on wgs website and everything checks out ok. R301 was like 1.5 ohms suppose to be 1.2ohms but that should be close enough. I only havent checked is ic u601 im not sure if i can check that with a meter. Its not the control pad tried swapping it already same problem. Interestingly the u5000 spec sheet says r618 should be 82ohms in reality it appears to be a 1.2 ohm resistor? I checked r618 on other chassys and they were all around 1ohm to 1.4 ohms or so. I reflowed a lot of the vertical section didnt help, think im out of ideas anyone else have one lol? Maybe i should try swapping u601?