U2000- No Width Control

Sypth

Active member
Joined
Nov 28, 2011
Messages
343
Reaction score
30
Location
Montgomery, Illinois
I just did a full cap kit on the monitor from a kit I got from twistedquarter. Noticed a lot of the solder points on it were dull, so I went around and made sure to get every single one of them with some new solder. Turned the thing on and it looked great and it had width control and everything. Now I lost it, I can't get it to work with the coil or adjustment, and it's weird because it'll come back from time to time and then it'll be gone again. Any suggestions?
 
Check your remote cable connections and your adjustment pot. Cracks, cold solder joints, and broken/loose wiring can cause intermittent function...
 
Thanks, I recently replaced the cable from the adjustment board, thinking that might be a possibility. The solder on the adjustment board was awful, so I touched that up, and I took a meter to the pot today and I believe its off by quiet a bit, it looks to be a 5K ohm and it'll only get up to around 1K but then drops when I turn it all the way to 700 ohm.
 
Back
Top Bottom