NASguy New member Joined Mar 3, 2011 Messages 123 Reaction score 0 Location Florida Mar 4, 2011 #1 I need to screw some PCBs down to sheets of wood. Any advice on what I should use? Or does it not really matter if it gets the job done? Thanks
I need to screw some PCBs down to sheets of wood. Any advice on what I should use? Or does it not really matter if it gets the job done? Thanks
Broodwich Well-known member Donor 6 years: 2012-2013, 2015, 2020, 2023-2024 VAPS Joined Feb 20, 2011 Messages 9,846 Reaction score 420 Location Albany, New York Mar 4, 2011 #2 PCB feet are what your looking for (pic2) top one for single boards, bottom one for dual lvl boards. These work well for middle supports on dual boards (just cut off the left section if there's no hole in bottom board) pointed end facing up. (pic1) do em right less problems in the long run Attachments standoff.jpg 24.8 KB · Views: 4 5_022_low.jpg 39.9 KB · Views: 6 Last edited: Mar 4, 2011
PCB feet are what your looking for (pic2) top one for single boards, bottom one for dual lvl boards. These work well for middle supports on dual boards (just cut off the left section if there's no hole in bottom board) pointed end facing up. (pic1) do em right less problems in the long run
OP OP NASguy New member Joined Mar 3, 2011 Messages 123 Reaction score 0 Location Florida Mar 4, 2011 #3 thanks for this!