I had an original Zaxxon machine that the monitor worked good but the pcb had some sound issues. So I put a 60 in 1 jamma conversion in this cab and the horizontal hold was flipping and the vertical was off center. I adjusted the pots on the back of the monitor and got it to stop flipping but it was off center still and the left side of the screen was wavy. Long story short, when I was adjusting one of the pots on the monitor it broke and now I have no picture. ANy advice on what I should do? Should I find someone to repair the monitor or just give it up and go LCD? Im afraid if I fix the monitor it will still look like crap. If I knew where to get the pot Im sure I could replace it myself but Im sure the original problem is not going to go away. Anybody know of someone in Fort Worth TX area who can fix the monitor? I called a few places but I didnt find anyone Id trust. Thanks for any help.
