I did a rebuild on this thing with a bob roberts kit. I installed a battery holder and the blocking diode. I even changed some additional resistors and diodes.
I just changed the 9 pin molex connector and I have the other 3 that need to be done still.
This thing has some type of 'drag' on the +5v line. When connected it drops below the 5v and I cannot figure out why so I started changing the molex' last. Currently the (2) 15 pins and the 3 pin still need to be changed and will be included.
It is a very clean board with no burn spots and really no acid damage either. Very little at any rate and I have neutralized whatever acid was there.
Additionally I have reflowed solder on virtually every point on the board on both top and bottom.
pictures tell the story
$45 shipped priority mail
I just changed the 9 pin molex connector and I have the other 3 that need to be done still.
This thing has some type of 'drag' on the +5v line. When connected it drops below the 5v and I cannot figure out why so I started changing the molex' last. Currently the (2) 15 pins and the 3 pin still need to be changed and will be included.
It is a very clean board with no burn spots and really no acid damage either. Very little at any rate and I have neutralized whatever acid was there.
Additionally I have reflowed solder on virtually every point on the board on both top and bottom.
pictures tell the story
$45 shipped priority mail
